When rain and precipitation flow towards your home, rather than away from it, water damage and moisture issues are bound to occur. There are several ways to prevent water damage to your home, such as regular gutter cleaning, downspout maintenance, and yard grading. Read on to learn how grade your yard to to prevent water damage in your home. Yard Grading: A Step-by-Step Guide Grading your yard is a big job that can be quite labor intensive. If, after reading the steps, you don’t feel comfortable in taking on the job, contact a professional landscaping company to assist. 1. Mark Utility Lines Before beginning the grading process, take the time to mark any utility lines in your yard with brightly colored flags or steaks. Utility lines include water, gas, telephone, and electric lines. Marking these lines will ensure that they won’t rupture during the digging process. 2. Obtain a Digging Permit Some cities and counties require homeowners to obtain a digging permit before grading their yard. Check with your city council to see if a permit is needed for your yard grading project. Better safe than sorry! 3. Identify Drainage Area After you’ve marked off the utility lines and obtained a digging permit (if necessary), the next step is to identify the nearest drainage area that you’d like the water to flow to. If you’re unable to utilize a public drain, you’ll need to divert the runoff to the edge of your property. 4. Start Digging! Dig up approximately eight inches of topsoil from all areas around your foundation. Set the freshly dug soil to the side – you’ll need it later! 5. Level Things Out To create a level surface, fill in uneven areas with the soil, and remove (dig up) soil from other areas. When removing excess soil from bumpy or uneven areas, be sure to press the remaining dirt down to smooth out the surface. When leveling out areas of depression, dig around the perimeter (approximately five-inches), then add in the excess soil, pressing it down to create a smooth and even surface. 6. Mark the Area Firstly, you’ll need to paint (spray paint works great) two stakes to use as markers. Then, drive one stake 12-inches away from your home’s foundation and the other 12-inches away from the drainage area. Once the stakes are firmly driven into the ground, connect the two with a colored string to determine the grade of your lawn. 7. Form a Downward Slope This is where the grading begins, as you’ll be moving the arranging the remaining soil on your lawn to form a downward slope. As you’re moving and arranging, periodically check to make sure the slope is accurate. To do this, simply place a 2×4 board on the slope, away from your home. Keep in mind, to achieve effective drainage, you’ll need a 2% grade at minimum. Here’s how you’ll determine the percentage of your grade: Place a leveling bar atop the 2×4 board. Raise/lower the 2×4 board until the leveler indicates the board is level. If the ground measures two-inches below the 2×4 board, you’ve got a 2% grade! 8. Rake & Till Using a rake, smooth the grade so that the soil lies evenly, then use a tiller to mix the topsoil you set aside in step 4 with the subsoil. 9. Plant Grass or Lay Sod Before planting grass or laying sod, allow the soil to settle for a few days. Keep in mind, if you’ve achieved a 2% slope, water will be absorbed by the soil, but the excess will drain away as intended. Water damage can be a very stressful situation to deal with, both personally and financially. Don’t allow yourself to fall victim to water damage when you can easily prevent such a thing from happening by following these steps proper landscaping techniques, and this helpful guide on how to properly grade your yard.